Liquid Silicone Below 0 Degrees

- Jul 21, 2020-


Note: below 0 degrees, the unit is Shore C. The hardness of 0 degrees Shore A is equal to 18 Shore C. Therefore, the liquid silica gel below 0 degrees has a Shore C hardness of less than 18C. The hardness range is 0-18C.


                                                                                                 The following are the silica gel parameters with 3-4 Shore C hardness of E600 specially adjusted below 0 degrees


                 

HY-E600 product specification




●Product Features


·The temperature range is -50℃-200℃, which can be used for a long time and maintain its soft and elastic properties.


·Environmental and non-toxic, passed SGS, ROSH environmental and non-toxic certification.


·It has excellent electrical properties and chemical stability, water resistance, ozone resistance, weathering resistance, non-corrosiveness, physiological inertness, non-toxic and tasteless, low linear shrinkage, and easy operation.


 


 ●Product Introduction


 ·HY-E600 is a two-component addition molding silicone material, which can be cured at room temperature or heated. 


●How to use and matters needing attention


·Mix the two components A and B according to the weight of 1:1, and then pour after vacuum deaeration. Room temperature (25 degrees)   30-40 minutes operation time, 4-5 hours complete curing; heating 60-120 degrees, can be fully cured within a few 30 minutes.


· Separate the container from the condensed silica gel during operation, and use tools that have not used room temperature silica gel to operate the silica gel.


 


●Technical parameters


Group  分


E600A


E60B


colour


translucent


Proportion  


1.15


1.11


Physical properties after mixing (25℃, 65%RH)


Mixing ratio (weight ratio)


A: B = 1: 1


Viscosity after mixing (CP)


1450 


Operating time 25℃ (min)


30±10


Initial curing time (h)


3-5


Hardness (Shore C)


3-4C (below 0 degrees)

Tensile strength (Kgf/cm2 )


1.4


Tearing strength (kgf/cm)


                     2.0


Elongation at break (% ) 


=466

*Viscosity, operating time, and hardness after curing can be adjusted according to customer needs.


 


Packing specification

   A: 25kg B: 25kg


   A: 200kg B: 200kg


Storage and transportation

·Shelf life: 12 months (should be stored at room temperature, in a dry bath and in a sealed container, not in contact with water to prevent deterioration);


·These products are non-dangerous goods and can be transported as general chemicals.