The vehicle needs to be maintained for a period of time. If it is not maintained, it will speed up the damage, the fuel consumption is high, there is no strength, the abrasive tools are the same, the people are the same, and the abrasive tools used to produce the silicone material are no exception. If the maintenance is not good, The power consumption and damage are greatly improved. A long-term production of a high-quality product without continuous maintenance of the mold may lead to many problems, so the maintenance of the mold is indispensable.
When the molds of silicone products manufacturers have been used for a long time, we have to do some maintenance, which not only can extend the life of the molds, but also help us to avoid any obstacles in the process of use, and also reduce the cost of repairing the molds. What are the losses caused by lost work and the basic maintenance of the mold?
1. In the usual operation, it is necessary to pay attention to whether the movable parts of the mold can be operated normally every day, and whether the vent hole and the water path are blocked by the waste of the silicone product. This is the most important step in the normal protection of the mold, because the long-term blockage of the silica gel waste does not have any gaps and air, and the oil is not allowed to enter, resulting in a very high probability of mold rust!
2. In addition to daily protection, the regular inspection of the mold can not be ignored. Check if the mold has loose screws, whether the wear-resistant piece is damaged, and whether the spring can be normally elastic.
3. When the mold is discontinued for a period of time, we must clean the mold. Adhere to the mold joint condition to prevent the mold from rusting. And put the mold in the box and put it in the box. In fact, the method of maintenance is very simple, as long as we pay more attention to the usual use, and these daily actions generally silicone rubber products manufacturers will carry out mold maintenance in a month, if the mold maintenance is not carried out for a long time, The secondary production will cause mold loss and poor product production!